 |
 |
 |
|
- For only 3 1/2" Louver size. 2 connector per slide. Connect FRONT Tilt Bar to vinyl Louver
- The distance between the center of the 2 connectors is: 3 1/8"
- Off White Milky Color
- Commonly used in Vinyl, Polysatin, By The Ways, Hunter Douglas Summerwind shutter
- Minimum Order Quantity applied when added to Cart.
- If this is the first time you do this repair, it's recommended to order extra 1-2 pieces to practice pushing the connectors in the louver hole properly.
- You MUST replace all the connectors attached to the same tilt bar, IF your shutter is more than 5 years old (due to sun damage). For example: if your shutter has 8 connections to the tilt bar, however only 3 were broken. You must replace ALL 8 connectors. Because as soon as you pull the tilt bar to insert the new glides, the rest (5 connectors) will be broken (if they are old & sun damaged). There's no way to prevent that from happening. So please double count and make sure you order enough.
If you are missing the tilt bar, part 5248 is the rod used with these connectors.
1/ Remove the old, broken connectors from louvers by grabbing the tilt bar and pull out.
2/ Insert the new connectors into louver. Insert the longer side in the louver hole first, then gently but firmly force the shorter side in the hole. Sometimes it's easier to push the shorter end in with your thumb nail.
3/ Remove 1 end cap of the tilt bar and slide the broken connectors out. If the end cap is very hard to remove, it may be glued.
4/ Slide the tilt bar slowly into the new connectors
5/ Cut (with scissors) the End (only) connectors as needed, it should not stick out from the tilt bar.
6/ Put the end cap back into tilt bar. Glue as needed.
|
|
|
 |
|
 |
|