 |
 |
 |
|
We assume you ALREADY connect & join the Remote Control to the shades. The videos below show you how to use the Remote with specific type of blinds and shades.
Learn how to control your powered blinds & shades, select your window covering types below:
BUTTON FUNCTIONS of the Remote Control (when pressed, the selected # will lit up):
- Group 1-6. You can add up to 6 group of shades to 1 remote. Each group control the shades separately, independently. Unless you have a huge home, for simplicity most consumer would assign 1 shade to each group and have 1 remote for each room. For example, you have 3 shades in Family Room. Assign group 1 to Left shade, 2 to Middle Shade, 3 to Right Shade, etc...
- ARROW Up/Down. Arrow UP=Open = Raise OR Arrow DOWN= Close = lower down the shade.
- STOP. Let you stop the shade (while open/close) wherever you want.
- ALL. Operate ALL groups at the same time. In the example above, Family Room, press ALL, will lower/raise ALL 3 shades at the same time.
- HEART. Heart button is your programmed Favorite position. It is set at manufacture at half way
Setting Limits on Shades (exclude Roller Screen Shade). Video of How to Set Limits of Shade (exclude Roller Screen) - On Shade, Press & Hold the Program button for 6 seconds. Shade will jog. Program button can be found on shade headrail, typically on the right (near the front).
- Release the Program button when shade jogs.
- Shade will travel to the fully Open, then fully Close position. This sets the new limit. NOTE: this procedure adjust the limits only, shade programming & group assignment is retained.
Setting Limits for Designer Roller & Screen Shade ONLY. To clear & Reset LOWER LIMIT.
Video of How to Set Limit for Designer Roller & Screen Shade Only
- on Remote, Press & Release the group # where shade is joined.
- on Headrail, press & continue to hold Program button until next step, 3, is complete
- on Remote, Press & Release the Close button.
- on Headrail, release the Program button.
- Use Remote to move shade to & stop at desired position (desired lower limit)
- on Remote, enter Program mode.
- on Headrail, Press & Hold the Program button.
- on Remote, Press & Release the Close button.
- on Headrail, release the Program button. Shade should jog.
- on Remote, exit Program mode.
|
|
|
 |
|
 |
|